Car Lift Jack Operating Guide 2 Ton 12V CAR TIRE CHANGE SCISSOR LIFT JACK

Scissor Car lift jack

2 Ton 12V CAR TIRE CHANGE SCISSOR LIFT JACK 

Electric car jack, electrical wrench is useful for driver who meets the flat tire in trip. It makes the replacing tire job easy and fast! The merit of this product: operate simply, don’t need to shake hardly the car jack by hand, you just need to insert the plug of the electrical car jack into the car lighter, then press the switch to jack the car easily. The design is scientific, small compact and portable! The replacing tires job is difficult, but with the electric car jack, the job will be easy and simply. Electrical car jack is especially suitable for lady, fatness and tall people.

The kit includes:

1*12V electric car jack

1*12V electric impact wrench

2*Sockets for to fit all popular sizes of wheel nut

1*Adaptor for connecting to either your cigar lighter or battery

1*Hub cap removing tool

2*Wheel chocks to stop vehicle moving while on the jack

1*Manual jack handle (in case of flat battery)

3*Spare fuses

1*Instruction manual

Specification:

Loading capacity: 2000kg

Supply voltage: 12V

Rated current: 13A

Rated power: 120W

Rising range: 12-35cm

Control cable's length: 4.3m

Torsional moment: 340N.M

Electric Car Jack And Wrench Electric Car Scissor Lift

操作指南

步骤1：把车子停在接近水平且安全牢固的位置，启动警示灯，并拉好制动器。用轮胎支垫或其他防滑物将轮胎稳，防止汽车滑动。

步骤2   将点烟器插头一端插入汔车点烟器上，另一端插入电动千斤顶控制手柄上的5.5MM（图1）

         

步骤3 将电动千斤顶放在底盘支架下，使其上平面对准汽车支撑点平面，使丝杆轴丝与 汽车运动方向保持一致；按下“∧”上升键，把车身慢慢顶起，直到轮胎离开地面。（图2）

步骤4用电动扳手将轮胎螺丝逐一松脱，拆卸下轮胎。（图3）

步骤5 更换备用轮胎后，用电动扳手紧固螺母和按住控制手柄上“∨ ”下降键，降下千斤顶。（图4）

Car Lift Jack Operating Guide

Step 1: parked the car in flat floor position, started warning lights, and pull the brakes. Put the slip support pad or other stable object on the back of  tire to prevent the car sliding.

Step 2: plug one cigarette lighter terminal into the car cigarette lighter, and the other one into an electric jack 5.5MM control  handle (Fig. 1)

         

Step 3: put the electric jack under the car chassis lead it to aligned on the anchor plane, so that the screw shaft wire consistent with the direction of movement of automobiles; press "∧" UP key, lift the car body slowly from the top, until tires off the ground. (Figure 2)

Step 4: with electric wrench to loosen the tire screws one by one, the removed tires. (Fig. 3)

Step 5: After replacing the spare tire, with an electric wrench to tighten the nut and hold down the control handle "∨" drop key to lowering the jack. (FIG. 4)